Dog Car Badge Laser Cutting Car Emblem

Show your love for dogs with these laser cut, inlayed, acrylic dog Edition car badges backed with 3M 300LSE adhesive tape. 

This is not a vinyl sticker! See photos for inlaying process. Simply find the perfect location on your car, truck, bike, RV, boat, etc., and peal and stick. 

Acrylic is weather, UV light and impact resistant, which means your badge will last for years without discoloring or deterioration. The industrial 3M adhesive backing is just as tough and can withstand temperatures ranging from -40 to 400 degrees Fahrenheit.

Badge should be applied to a clean, flat surface. The badge will tolerate slight bending, but don't over do it or you risk cracking the acrylic. The adhesive is pressure sensitive, so apply firm pressure over the entire surface of the badge for roughly a minute. The adhesive is very sticky, once it's stuck, it's stuck. I recommend lining up the badge's location with painter's tape, then apply the badge along the tape line. 

The acrylic and adhesive are tough and can withstand a drive through the car wash. Use a cotton or microfiber cloth to clean the badge.